TCCoA Forums banner

1 - 20 of 51 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter #1
I have a pearl white 1997 LSC that I am parting out. The car is complete, so ALMOST everything is available.

Please let me know what you need and I will send you a price with shipping. Please include zip code, whether its business or residential and note if its a PO Box.

I will post a BUNCH of pictures.

Good Black LSC Perforated Seats - NO rips, tears - Will sell Whole SEAT or Just COVERS
$250 Fronts (w/o tracks)​
$100 Rear Upper and Lower​
Drivers Seat Track Assembly with Motors, etc $150
Passenger Seat Track Assembly with Motors, etc $100
LSC Tail lamps $45 per side
Neon Lamp – TBD (need to check condition and whether working)
ABS Sensors $20 each
Gauge Cluster - $50
Cup Holders – Not BROKEN $80
Radio Trim $35
LSC Moldings – ALL Available
Door Panels $100 each (have two rights, one left)
Left Door Panel with broken tab $50
Good Doors, Hood, Trunk Lid – prefer PU ONLY
Good Fenders - $75 each
Front Bumper Cover $150
Rear Bumper Cover with a dented left corner $100
LSC Grille $125
License Plate Bracket – Minor Cracks $50

Most likely NOT AVAILABLE (will consider if there is interest in CORES)
  1. Engine and Main Harness- engine doesn't run,
  • Transmission - Condition UNKNOWN
  • Chrome Wheels are in POOR condition
 

Attachments

·
Registered
Joined
·
42 Posts
Discussion Starter #2
Here are a few more pictures. Some close-ups. Please contact me with any offers or questions. I will also try to respond daily on forum.
 

Attachments

·
Super Moderator
Joined
·
12,072 Posts
How much for the gear shifter?

... and refresh my memory, does the Mark VIII have the OD switch button on the side of the shifter?
 

·
Registered
Joined
·
1,646 Posts
How much for the gear shifter?

... and refresh my memory, does the Mark VIII have the OD switch button on the side of the shifter?
Yes Ron it does.

I am interested in a centercap from one of the wheels, and a fender liner retainer pin/tab thing.
 

·
Premium Member
Joined
·
556 Posts
Rear lower control arms?
 

·
Premium Member
Joined
·
515 Posts
I would be interested in the other three wheel center caps.
 

·
Registered
Joined
·
3,762 Posts
I need the front floor mats!! I sent you a PM.
 

·
Registered
Joined
·
3 Posts
spare donut available?

Hello,

I live in SE Massachusetts and I am wondering if the donut spare is up for sale. Looking to fit an MN12 with 17" aftermarket rims. If you could give me a price for the donut and shipping to 02360, Id appreciate it.

Thanks for your time,
Quix
 

·
Registered
Joined
·
42 Posts
Discussion Starter #10
Gear Shifter Assembly

How much for the gear shifter?

... and refresh my memory, does the Mark VIII have the OD switch button on the side of the shifter?
I assume you mean the gear shifter assembly. $50 including shipping. If you just want the shift handle (with button and OD Switch I'll sell for $35. Shipping assumes US only.
 

·
Registered
Joined
·
42 Posts
Discussion Starter #11
Hello,

I live in SE Massachusetts and I am wondering if the donut spare is up for sale. Looking to fit an MN12 with 17" aftermarket rims. If you could give me a price for the donut and shipping to 02360, Id appreciate it.

Thanks for your time,
Quix
I do have a couple of donuts available. Its the standard Mark VIII donut and all Mark VIII's have 225/60R16 tires. I am unsure of what you are expecting based on your comment about your 17" Wheels. I'll weigh it tomorrow and send you a price. I am assuming that UPS or Fedex would be the best rate, but need to know if its residential or business as they both charge extra for residential, especially in what they consider as 'rural' zones.
 

·
Registered
Joined
·
42 Posts
Discussion Starter #12
Intake Tube (from MAF to throttle body) $35 plus shipping

How much for the intake tube? Thanks.
Intake Tube (from MAF to throttle body) $35 plus shipping.

If interested I'll pull it off tomorrow and get an exact shipping quote. I see you're in CA, but a zip code would be helpful. For me to compare USPS to UPS and Fedex, please confirm its a street address and whether or not its residential or business.
 

·
Registered
Joined
·
42 Posts
Discussion Starter #13
Chrome Center Cap and Retainer Pin for Liner

Yes Ron it does.

I am interested in a centercap from one of the wheels, and a fender liner retainer pin/tab thing.
This car has chrome caps. I also have silver if that's what you need.

Price for the Cap and Pin including 1st Class Shipping via USPS is $16. Will be well protected inside a padded envelope.

I prefer PayPal if you are interested.
 

·
Registered
Joined
·
42 Posts
Discussion Starter #14
Rear Lower Control Arms

Rear lower control arms?
$50 each or $85 for the pair. Shipping would be $35. Would need 2 weeks after payment to shipment.
 

·
Super Moderator
Joined
·
12,072 Posts
I assume you mean the gear shifter assembly. $50 including shipping. If you just want the shift handle (with button and OD Switch I'll sell for $35. Shipping assumes US only.
I just need the shift handle with button and OD switch. Please be careful removing so as not to break the OD switch wire!

I'm in the Charlotte, NC area.

What's your paypal address and I'll send you payment. Thanks.
 

·
Registered
Joined
·
3 Posts
Hey,

I upgraded to aftermarket 17" rims with stock bolt pattern of 5 x 4.25 circle. 13" front with PBRs and 11.6" Mustang Rear Brakes so I need a spare rim that will clear the PBR and the repositioned rears stock calipers. For shipping, you can price the shipping costs to - Cape Cargo Inc. 345 Old Plymouth Rd, Sagamore Beach, MA 02562. Please let me know if everything is clear, and let me know what the shipping fee will be.

Thanks,
Quix

p.s. the part # of what I am looking for is F3LY1K007-A
 

·
Premium Member
Joined
·
556 Posts
I'm going to pass on the control arms at this point in time thanks tho
 

·
Registered
Joined
·
461 Posts
Im in Jersey as well. Do you know what gears it has in the rear?
 
1 - 20 of 51 Posts
Top