I am putting 3" on my car from the cats back to right befor the rear end. from right befor the rear end to 2 mufflers 2 1/2 al moduler bends. My question is dose any one have pics on how they branched off from the 3 inch to the 2 1/2 befor the rear end. the pip dose not need to be the same size i'm just trying to get ideas.
3" Exhaust On A 95 Bird
1 - 3 of 3 Posts
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Engine coolant drains out as I pour it in
Engine - 4.6L & 5.4LHey all, I have a 95 v8 tbird I recently purchased and I did an engine coolant flush. When I pour in the coolant I can watch it drain out rapidly from the coolant container. I can't seem to find a leak anywhere. Any ideas where it could be leaking? I don't know the configuration of the cooling...- 2
- 30
-
Engine fan same for 94/97
Engine - 4.6L & 5.4LIs the fan the same plug and play for a 94/97 cougar 4.6 Got fan at junkyard from 96 going on 95- 2
- 54
-
Spark plug?
Engine - 4.6L & 5.4LHi all. I have a 1997 Ford T-Bird with a all stock 4.6l. Since December 2011 when I swapped the plugs I've put approx. 13,000 miles on it. There are no codes and other than the miss it idles and runs great once the speed is above about 40 MPH. It was doing the exact same thing prior to swapping...- 33
- 6K
-
weird cutting out issue on 1-2 shift
Engine - 4.6L & 5.4LHi, I have been chasing a weird cutting out issue on my 95 cougar 4.6 sometimes it will do it under light acceleration but more likely under wot when fully warmed up. cruising at 25-30 mph if i decide to wot it will shift down to 1st and right before 2 it cuts out and free revs. it will go...- 8
- 346
-
Nightstar · updated
-
rebuild newbie
Engine - 4.6L & 5.4LLooking for basic steps in rebuilding a top end of a motor. I'm going to use ported pi heads and a camshaft. Looking to make over 275 hp and have a more torque driven power plant. What simple things should I replace or address as I put the new cylinder heads on.- 8
- 484
Join now to ask and comment!