TCCoA Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
395 Posts
Discussion Starter #1
Well,

4th place in Modified catagory.....I was told the engine compartment looked a lil to busy (which means not to pretty!)...Time to purty it up. WHat have you gusy all done as far as rerouting. Ive seen complete engine pictures but no straighfoward advice.

As always thanks in advance!!

Damon
 

·
Registered
Joined
·
3,391 Posts

·
Registered
Joined
·
395 Posts
Discussion Starter #6
It was a bit cleaner as this is a slightly older picture however I think I am more concerned with what was done as far as wiring harness. Lenghthening as to get it from off the top of setup, where was it stashed? A new intake will eventually be made in which I will reroute any air hoses. Is there a place I can get new connectors ect for the sensors? I guess besides lookingf at pictures what does anyoen reccomend? Or avoid when doing this? The FMU will most likely be ditched as well in favour of a proper tune with large rinjectors

 
1 - 6 of 6 Posts
Top