TCCoA Forums banner
1 - 1 of 1 Posts

153 Posts
Discussion Starter · #1 ·
Yesterday I finally got around to putting my PBR's. Before I installed the new calipers the brake pedal was kinda low. If I would "slap" the brake pedal then hold it I would get a nice high brake pedal. I attributed this to my shoes and drums on the back being shot (which they were). So I installed new shoes & drums on the back and installed the pbr's w/new pads on the front and blead it all. Now I am still getting the low brake pedal unless I do what I stated above. I don't believe I've ever noticed the brake pedal drifting towards the floor, but I believe the master cylinder is bad.
So does anyone make a better master cylinder that will work on our cars to go with the pbr's?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.