TCCoA Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,747 Posts
Discussion Starter #1
Ok, This is the last step I need to do before everythings ready for the PI intake swap, and now I do not know how to take off the bracket on the back of the engine where the coolant tube "interlaces" with.
 

·
Registered
Joined
·
1,747 Posts
Discussion Starter #2
could I cut the old tube? I know Im gonna have to reroute anyways where it goes into the heater core. I just need some advice to get everything ready for when the manifold comes in
 

·
Registered
Joined
·
3,183 Posts
When i did my pi swap along long long time ago i just cut it and ran heater hose where i needed too.. it held up 3 years till i swapped motors..
 
1 - 3 of 3 Posts
Top