TCCoA Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2,894 Posts
Discussion Starter #1
ok, what tools would i need to have for a full swap of my k meber, i know the out of the ordinay tool im going to need would be at the least a large hex head socket of some size, probably around a t-60, but anything else i need to know, before i tackle something like this?
 

·
Registered
Joined
·
1,598 Posts
You better have a 36" breaker bar, as those funny bolts are tight! (if you can borrow a compressor, and air wrench it may even be easier)... Have fun, but dont drop anything on yourself
jake
 

·
Registered
Joined
·
2,894 Posts
Discussion Starter #3
yeah i was planing on useing compressed air, my 1000ft lb air gun will get them bolts off
 
1 - 3 of 3 Posts
Top