TCCoA Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter #1
I haven't (yet LOL) this is my weekend project for a buddy of mine.
I have 3 questions.
1 where the frag is the pump is outside the pan or in the pan.
2 if it's in the pan how high do you have to raise the engine to get to it?
3 will a SC pump work on a non SC block?
 

·
Registered
Joined
·
47 Posts
The oil pump beleive it of not, is the same place where the oil Folter attaches, so it's outside the block, now when I did my SC's oil pump I did it with the motor out of the car, but it looks like with a LOT and I mean ALOT of time and care you could do it with the motor in the car, as for thew possibility of the SC oil Pump, I don't know, but I'm sure it's a yes, since I've accedentally received the wrong oil pump and it fit fine it just flowed a whole lot less... your best bet is a 94-95 SC oil pump if the do fit... they where and upgraded design the tried to make up for the lack of decent oiling in the 3.8's.


Jim;)
 

·
Registered
Joined
·
3,902 Posts
all 3.8 fords the same

All 3.8 Fords have the oil pumps built into the front cover. You can just buy a rebuild kit. It comes with new gears and some other stuff(its been a year and half since i did it). Be sure to prime the pump when you put it back on!! :)
-Rob
 
1 - 3 of 3 Posts
Top