TCCoA Forums banner
1 - 1 of 1 Posts

2,806 Posts
Discussion Starter · #1 ·
I saw this a while back over on Modular Depot and thought it was good informnation to post here. Apparently the throttlebody from an Aviator is 70mm, compared to 65mm stock, and can be bought directly from Ford for around $80. This throttle body will bolt up to 96/97 MN12's and those with PI swaps. Much cheaper way to go than with an aftermarket unit.

Here is the thread where it has been discussed:

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.