Fuel Door Quarter Panel Area

Zep5.0 · 2022-09-05T12:16:36-0400

Wish I would have known a couple months ago before I scrapped my parts car. That looks rough...

supergordo · 2022-09-05T12:53:05-0400

Pockets127 is in the final stages of parting out a 1996. Send him a message.

jb351 · 2022-09-05T13:20:38-0400

supergordo said:
Pockets127 is in the final stages of parting out a 1996. Send him a message.

Will do. Thanks.

jco1385 · 2022-09-05T19:25:25-0400

I replied on SCCoA, but maybe you'll see it here first...

I've got a car I could cut. Draw your lines where you want it and tell me what it's worth.

CDsDontBurn · 2022-09-12T01:28:44-0400

jco1385 said:
I replied on SCCoA, but maybe you'll see it here first...

I've got a car I could cut. Draw your lines where you want it and tell me what it's worth. View attachment 50606

Looks to be about this much here. I'd cut an even bigger portion of that piece just in case. OP can fine tune what they need exactly, I'd say.

Zep5.0 · 2022-09-12T09:17:05-0400

It's venture to guess any body shop would want most of the panel. Welding anywhere in the flat part of that fender is going to cause a lot of extra body work.

jco1385 · 2022-09-19T19:13:44-0400

That would be the absolute minimun needed. I'm assuming he would want a much bigger piece. I'm not cutting anything until I hear from OP.

jb351 · 2022-09-19T21:18:30-0400

Apologies for the delayed response. Shifts at work got turned upside down for a few weeks leaving me no time for anything. It would be a pretty good chunk I would be looking for and then cut out what I need. Probably whatever large piece would fit in a normal shipping box. I need to check a local salvage yard tomorrow but I don't think they have anything and I'm still thinking about cutting and welding an aftermarket one in if needed such as these. https://www.summitracing.com/parts/hag-fd45rq https://www.summitracing.com/parts/tnk-ffd-a

I need to make a decision asap though as I need to re-install the tank soon.

jco1385 · 2022-09-19T22:32:25-0400

I'm not sure what shipping would be, but I think I could get this OEM metal in your hands for less than those options. You think 3 or 4 inches from the lid will be good? Something like this and then all the way to the bottom of the panel behind the bumper cover? I could also go all the way up to the trunk lid if that would help you fit it up. Just let me know and I can get it out fairly quick.

jco1385 · 2022-11-08T19:48:50-0500

Because I like before and afters, I'll post this pic here.

jb351 · 2022-11-17T15:21:09-0500

The panel arrived today and is in perfect shape. Thanks again for all of your help.