TCCoA Forums banner

1 - 3 of 3 Posts

·
Super Moderator
Joined
·
10,576 Posts
Discussion Starter #1
I've tried about everything I can think of to get these bearings out;

It's the dual port throttle body on my 97 DOHC engine; They feel really rough, and I'd like to replace them.

They are pressed into a cup at each side, and the diameter of the hole in the aluminum matches the bearing ID. And they're fully down.

Any Ideas?

I've tried getting tools in there, but there is no purchase without taking out the aluminum to the inside of the bearing. I'd rather not kill the TB... :)

There has to be a way...
 
1 - 3 of 3 Posts
Top