TCCoA Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
296 Posts
Discussion Starter #1
there was once a person on this website that had a nice web page set for drilling our hubs to the 4.5 bolt pattern with good prices. i used to have his page bookmarked but my old computer fried so i lost it. i believe it was some type of geocity webpage. anyhelp? thanks!
 

·
Registered
Joined
·
9,966 Posts
it may be cheaper to swap in fresh bearings and do the actual hubswap.
 

·
Registered
Joined
·
296 Posts
Discussion Starter #3
i have a parts car that im gonna pull the hubs off. the guys prices were around 60$ per pair so if i do it this way i'll have no down time and i wont have to buy 200$ cobra rear hubs plus the 50$ mustang hubs at a JY
 

·
Registered
Joined
·
1,846 Posts
Not sure if this guy was ever on this site, but here is a link to his IRS Machining Services webpage.

Jim
 

·
Registered
Joined
·
9,966 Posts
i have a parts car that im gonna pull the hubs off. the guys prices were around 60$ per pair so if i do it this way i'll have no down time and i wont have to buy 200$ cobra rear hubs plus the 50$ mustang hubs at a JY
you are willingly going to use old hubs sitting at a junk yard? new ones are 70$.
 
1 - 6 of 6 Posts
Top