TCCoA Forums banner

1 - 20 of 53 Posts

·
Registered
Joined
·
975 Posts
Discussion Starter #1
Ok, I've spent the last 3 weekends doing the PI top end swap...and finally got the car started :)

This is my public "Thank you" thread --

XR7-4.6 (Matt) helped beyond belief, especially with engine timing

rmfk13 (Rob) a bunch of bolt tightening and sawzall expert :)

Embalmer (Jim) tons of advice

Its not a clean install, and still needs some fine tuning. EGR is throwing a code...a little air in the cooling system, bolt the exhaust completely on...but it runs!!

I'm tired but glad to have this swap 95% done...can't wait to drive it.
 

·
Registered
Joined
·
975 Posts
Discussion Starter #11
I knew you'd comment about that...just remember this is when I was still in the putting it together phase. It is really funny though.
 

·
Registered
Joined
·
975 Posts
Discussion Starter #13
No, its going from the connector that I have on the crossover to the heater core. I have the crown vic tube through the valley.
 
1 - 20 of 53 Posts
Top