TCCoA Forums banner

1 - 20 of 20 Posts

·
Registered
Joined
·
179 Posts
Discussion Starter #1
Alright I have a 1993 mark 8 one piece aluminum driveshaft. It has brand new U joints all pressed in, good to go, very clean. $130 + ship OBO
 

·
13's or Mildly Broken
Joined
·
2,670 Posts
I don't think so, not without some modification with difference in transmissions. It's from a 4R70W and you have an AOD.

-Melon
 

·
Premium Member
Joined
·
1,372 Posts
I don't think there is a length or spline difference between the AOD AODE and 4R70W. but I could be wrong.
 

·
Registered
Joined
·
836 Posts
is it balanced already? ill take dibs if it is. also do you know how much weight it saves compared to a stock t bird driveshaft
 

·
Registered
Joined
·
836 Posts
also did you have it installed on yours just curios if you had any issues with it?
 

·
Registered
Joined
·
179 Posts
Discussion Starter #7
it is still factory balanced and too the best of my knowledge it is still balanced, no i never installed it, just sat in the garage. i had fitment issues because of my v6 . as for weight savings, i believe its 6-7 pounds or so, this thing is extremely light. and since its rotational mass that will help quite a bit. i have mikestbird443 as 1st dibs, if he falls through, paintme205 its yours, i'll get a shipping quote asap
 

·
Registered
Joined
·
836 Posts
ok thanks for the info
 

·
Faster than Porkchop
Joined
·
2,037 Posts
I have one that has new yoke and new splicer u joints and was balanced to 3500 rpm .

Could not use it because of my 4.10 gears .

I have receipts for the work that total over 100.00 .

BTW I bought the Dynotech 4in shaft from SCP , ouch !!

Edit : pending sale
 

·
Faster than Porkchop
Joined
·
2,037 Posts
Why couldn't you use it with 4.10's?
My driveshaft was tested only for 3500rpm .

I just dont want to take a chance so I bought a Dynotech driveshaft that I received today .

It was a nice day since I also got/installed the Xcal tune today !!;)

Edit : I had already said that .
 

·
Registered
Joined
·
892 Posts
My driveshaft was tested only for 3500rpm .

I just dont want to take a chance so I bought a Dynotech driveshaft that I received today .

It was a nice day since I also got/installed the Xcal tune today !!;)

Edit : I had already said that .
Those are nice times!

Brad
 

·
Registered
Joined
·
157 Posts
lemme think on it ill let you know...pending my dad isnt an ass and lets me use his paypal i figure it should be good.
 

·
Registered
Joined
·
892 Posts
1 - 20 of 20 Posts
Top