TCCoA Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
55 Posts
Discussion Starter #1
Hi everyone

I have a unusual situation with my PI swap, been searching around for an answer but havent found one yet, I blew up the original 4.6 in my 94 thunderbird a while back and decided to replace it with a low milage PI engine from a 2001 Mustang GT, when I went to swap the motor mounts I discovered that part of the PI block prevents me from bolting the original mounts flush to the block, is this a common prob or do I need a diffrent year of motor mount?

any advice would be appreciated

thanks

Ron
 
1 - 2 of 2 Posts
Top