TCCoA Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2,638 Posts
Discussion Starter #1
I went to Pull-A-Part today to find a cap to fit the clutch fluid reservoir on my Ranger and what do I find there? A '96 LX 4.6. I don't think I have ever seen a 96/97 at Pull-A-Part, much less a V8. It had pretty decent leather seats so I snagged front and rear for under $60.
Does anyone have decent mocha leather seats to trade for these? If not, how will the saddle leather seats look in a mocha interior? Will it stand out too much or will it contrast nicely?
I also snagged the fuel rail and intake tube if anybody needs them to put a PI intake (or a 96/97 NPI) on his 94/95. I would have grabbed the fuel lines but I didn't have the disconnect tool with me.
 

·
Super Moderator
Joined
·
7,528 Posts
you should have just cut the lines behind the filter, and taken the rails too.
 

·
Chapter Director Coordinator
Joined
·
6,253 Posts
i think i have a set of mocha backs.. some slight tearing in the driver side... my saddle tan driver seat is all fugged up
 
1 - 4 of 4 Posts
Top