TCCoA Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
95 Posts
Discussion Starter · #1 ·
I need a little help! I was pulling my engine to swap in a new 306. I disconnected the wires to the power distribution box next to the battery and marked them with tape and pencil. Well little did I know that the pencil marking just smudged off and now I am stuck with a few of the wires unmarked. Can anyone take a quick picture of the wires under the power distribution box so I can match them with mine and replace them. Thanks for the help! By the way my #5 piston melted so that is why I am replacing the block with a CHP 306.
 

·
Registered
Joined
·
647 Posts
John P is that you?

I can snap some pics for you, no problem. I relocated my PDB back a little to make room for the MSD, but I can probably get the camera in there. Anything you're looking for specifically?

Email me off-line if you want: [email protected]

- Jeff
 
1 - 2 of 2 Posts
Top