TCCoA Forums banner

1 - 13 of 13 Posts

·
Registered
Joined
·
2,008 Posts
Discussion Starter #1
I need to make a couple spacers for the brace that ties the tunnel together. It's probably a 24inch long sheet metal brace with 2 small screws in each end. Could somebody tell me the width of the piece, the spacing of the holes, and the size of the wholes? I'm going to burn a couple on the laser.

Thanks
David
 

·
Registered
Joined
·
2,008 Posts
Discussion Starter #5
I'm just making spacers for mine as the exhaust hits, will not be making the full cross member. I modeled it after the slotted side.
 

·
Registered
Joined
·
2,008 Posts
Discussion Starter #10
5.00 plus shipping for 2 spacers. One for each side of the brace. Not trying to make a killing. Only stipulation would be cash or check since paypal would cut into my spoils
 

·
Super Moderator
Joined
·
11,017 Posts

·
50 years of Mercury Cougar 1967/2017
Joined
·
1,270 Posts
Just wondering, what does that brace do besides hold up
the dual exhaust pipes?
 

·
Registered
Joined
·
2,008 Posts
Discussion Starter #13
the pipes are not supposed to touch it, it just ties the 2 floor pans together as a stiffener since the transmission tunnel is so god awful big.

a little tacky tacky and we are together.


 
1 - 13 of 13 Posts
Top