TCCoA Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter · #1 ·
I came across a 01 F150 engine with the bottom end blown. pulled the heads and they are good.
Are the heads and cams good for the PI swap since these are from a truck?
 

·
Registered
Joined
·
1,522 Posts
Yes.

However - remove the rockers and see if the cams spin freely, from my experience its a 50/50 chance they won't. Usually these motors run low on oil and gouge the cam bores.
 

·
Registered
Joined
·
27 Posts
Discussion Starter · #3 ·
Sweet. The heads were free, I'll pull the finger followers and check.
thanks.
 

·
Registered
Joined
·
2,806 Posts
Didi you pull the valve covers? If not you need to find some windsor valve covers to go with those heads.

-Miller
 

·
Registered
Joined
·
27 Posts
Discussion Starter · #5 ·
Yes I kept the valve covers.
 
1 - 6 of 6 Posts
Top