TCCoA Forums banner
1 - 1 of 1 Posts

31 Posts
Discussion Starter · #1 ·
Hey guys,

I am located in the Annapolis area. I am in the middle of a complete rebuild of my engine on my 4.6l 96 thunderbird. In case you want to know this is what I did.

Block de-greased and bored: .030 over
Manley Forged Rods
Forged Pistons
PI Heads and Intake
New Comp Cams
Stainless Headers
new catalytic converter
Dynomax catback
Transgo Transmission reprogram (On a re-manufactured trans)
80 mm PMAS blow through MAF
42lb injectors
Underdrive pulleys
225 Fuel Pump
Racing Seats
Painted entire interior
Larger oil Pan
High Flow oil pump.
Stainless steel engine hardware swap (bolts)
New Power steering pump
New Harmonic Balancer
New High_Torque starter.
AEM cold air intake (Existing before rebuild)

Where is a good dyno to take this car and have it tuned? I am in the middle of the state so I can go up or down. It will be a 1-2 hour drive either way.


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.