TCCoA Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
5,978 Posts
Discussion Starter · #1 · (Edited)
i had done the rear disc conversion on my cat and i had an average pedal. now that the engine is out and i have to dismantle the gas tank and exhaust. i want to make this right , the donor car was a 91 , i left the cross feed style on the car. now, i need the s/c prop valve? and a 2 line master ? if i remember this right i have to run 1 line to the back of the car and then cross it over form the left to the right? any input on this ? let me know justin
 

·
Registered
Joined
·
5,978 Posts
Discussion Starter · #2 ·
so i cant beleive noone has posted to his thread, i am startign to figure out the issue, the master bore on the 89 and 89 only is 5/16 woefuly small for what it is and what i am asking of it, also 90-93 non abs used a 1 inch bore so i am trying that first
 
1 - 2 of 2 Posts
Top