[sweet99]

Looks like a top end intake but looks sharp also. I think I got the name correct, it's 3:30AM and I will confirm it in the daylight hours. Of course at $1495. I would have to pass. Someone on one of the Mustang sites is making something similar but with 2-3" runners I suspect it will not come on until 6000+rpm! Mark

 

[kdanner]

Have an extra here, never bolted to an engine. $1000, ready to buy?

 

[DMcBrideBoston]

lmao

 

[KrAzyT]

yeah i heard upper rpms.. like high rpms

 

[General Zod]

Have an extra here, never bolted to an engine. $1000, ready to buy?

i 'member seein that piece in your garage....quite a beauty! haha


so since you said "extra" kris, does that mean one will go into the Bird or GT?

 

[kdanner]

Maybe Oscar, would have to be the GT, as it is a PI intake.

 

[David_viny]

I must be out of the loop here; are there any pics or info available? I get a motorcycle exhaust place with Google.

Need some linkage

Not that I can afford it

 

[firescout211]

i hang around modualr depot alot. there are NO aftermarket intake that are worth the MONEY at this point for the 4.6 if you are staying n/a. even the bullet intake only gives you 4-10 hp. but it also weighs 30 pounds and costs $1300 with teh install kit. now if you are going with a blower, the p-51, RIECHART RACING, and even a couple others are well worth the $$$$. intakes are worth 30+ hp when blown. trickflow and elderbrach are supposedly comin out with thier intakes shortly. waiting for prices and dyno #'s.

 

[sweet99]

Riechart, thanks. cool looking piece. TF/Summit is going to list at $799. and Edelbrock isn't doing one unless you consider the one they already did. Its single plane. Can be had for a carb or EFI. Another stratospheric rpm piece. The TF/Summit piece is built after the Bullitt. Time will tell. Sweet

 

[twin turbo 281]

There will be plenty more to come. Its been 12 years since they killed the 5.0 in the stangs anyways and there still coming up with better intakes all the time.

 

[Casper]

the thing is the pushrod 5.0 intake is much easier to design and produce than the modular intake unit...