TCCoA Forums banner

1 - 8 of 8 Posts

·
Eleventeenth Gear Poster
Joined
·
3,067 Posts
Good find, those are much less than the MN12 Performance bushings. I wonder how they compare in fit and quality?
 

·
Fry Rice Specialist
Joined
·
4,794 Posts
just wonder a stupid question, those can be use for a mark 8 alu arm and bolt to mn12 right?
 

·
Registered
Joined
·
252 Posts
I have been using that kit for the last year and a half in my new car. They are plenty stiff. I took the knuckles and bushings to someone with a real press, as my vise would not press these in too easily.

chuacw said:
just wonder a stupid question, those can be use for a mark 8 alu arm and bolt to mn12 right?
They just fit into the knuckle, not the control arm.
 

·
Fry Rice Specialist
Joined
·
4,794 Posts
did it improve handling or anything at all?
 

·
Registered
Joined
·
252 Posts
Obviously, they took some of the compliance out of the rear suspension. I believe that it stiffened up the rear a bunch. I have had no wheelhop issues so far after four trips to the strip.

I greased them up really good when I put them in, and I have yet to hear a squeak out of them.
 
1 - 8 of 8 Posts
Top