TCCoA Forums banner
1 - 1 of 35 Posts

· Registered
6,521 Posts
Digging up an old one. I think this post is a good candidate for the Tech Articles. The one that was written by the old MN12performance site was really vague and didn't explain parts well or have good pics. I think this is the way to go if you want the lifts.

One thing I would add, if you get aftermarket lifts instead of F4ZZ-63406A10-B like I did it doesnt come with the ball stud that goes into the coupler. You can order those from McMaster also:

10mm ball stud: 9512K73 $1.03 ea.
I would just like to add, that I had to re-tap the threads to a different thread pitch on one half of the coupler in order to screw the ball stud into one end of the coupler, Mcmaster might have one that is correct, it's been two years since I did this mod, three or four since I did this mod to my 95 bird.
1 - 1 of 35 Posts