TCCoA Forums banner
1 - 2 of 2 Posts

·
3rd Gear Chirper
Joined
·
2,399 Posts
Discussion Starter · #1 ·
Ok, we all know that if one were to use LED bulbs on a 94+ MN12, then the factory electronic flasher would see this as a burnt-out bulb and flash faster to indicate such.

So, does anyone know where I can get a flasher that doesn't sense the load on it?

I absolutely refuse to use those resistor kits they sell for this purpose, as they get hot enough that I would not be comfortable using them without a heat sink and cooling fan(s) which is more trouble than LED's are worth.
 

·
Very nice... How Much?
Joined
·
175 Posts
ummmm... I have the resistors.... They dont get that hot actually.... I just have mune ziptied in the air so they dot land and touch nything....
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top