TCCoA Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
188 Posts
Discussion Starter #1
I just was wondering or would you have to swap the heads to go with it?:confused:
 

·
Registered
Joined
·
188 Posts
Discussion Starter #2
sorry forgot the intake part in that ?

I ment will a DOHC intake plenumfit the SOHC it is off of a Mark VIII?
 

·
Registered
Joined
·
2,314 Posts
The Mark Engine uses actuators to open the long and short tubes at different RPM's doesn't it? This would be a nightmare to make happen without the Mark computer, I really doubt that it is possible to make it function properly if it does fit. For the time it would take you could problaby have the whole DOHC motor in.
 

·
Refrigerator Raider Hater
Joined
·
11,719 Posts
I believe...

The thing you speak of is the IRMCs. There are delete kits, but you'd lose alot of low-end torque.

On a sidenote, my SHO has a dual runner intake, and the secondaries are controlled by vacuum. Might be possible to make them vacuum actuated.
 
1 - 4 of 4 Posts
Top